Finally! Under jingles that aren’t permanent, and even better, they can be engaged or disengaged!
 
This dual-purpose jingle is designed to be used under or over your hi-hat cymbals.  Easily attach it to either your hi-hat tube or your hi-hat rod.  The five sets of jingles on the Under/Over Jingle overlap to give you a full jingle sound. 
 
USE IT UNDER:
Use the OUTER part of the clamp to attach the Under/Over Jingle to your hi-hat tube.
You will need at least 4” of space on your hi-hat tube below your cymbal to use the Under/Over Jingle.
Add a subtle jingle sound to spice up your grooves without taking up playable “real estate”.
Adjust how much the Under/Over Jingle reacts with the bottom cymbal by pressing the pedal lighter or heavier.
Have the Under/Over Jingle tight to your bottom hi-hat cymbal to angle your cymbal, changing the feel of the hi-hats.  It will give you a “springy” feel.
Easily loosen and tighten the Under/Over Jingle with one hand.
Slid the Under/Over Jingle down the tube away from your cymbal to disengage the jingles, allowing you to effectively mute them. (You will need approximately 4.5” of space on your hi-hat tube to fully disengage the Under/Over Jingle.)
Experiment with placement.  Placing the Under/Over Jingle directly under where you are striking the hi-hats vs. placing it on the opposite side away from you, will activate the jingles differently.
 
USE IT OVER:
Use the INNER part of the clamp to attach the Under/Over Jingle to your hi-hat rod.
Rest the Under/Over Jingle on your top hi-hat cymbal to get a louder, more active jingle sound, like a ching-ring.
The crimping in the flat metal arm allows the arm to flex, giving the jingles more motion when suspended.
Clamp the Under/Over Jingle on the outer side of your hi-hats to keep them out of the way, giving you plenty of room for sticking.
 
The Under/Over Jingle is NOT a striking instrument and WILL be damaged if played as such.
 
-Designed to work with 13” or 14” hi-hat cymbals. 
-Universal clamp fits most hi-hat tubes. The opening of the jaw ranges from 1/2” to 2” to fit over your stand tube.  The opening of the inner part of the clamp ranges from 1/4” to 3/8” to fit your hi hat rod. 
-You will need approximately 4.5” of space on your hi-hat tube to fully disengage the Under/Over Jingle.  If you have your hi-hat setup low or have a short hi-hat tube, you will have less room to move the Under/Over Jingle away from your lower cymbal.  This may not allow you to fully disengage the jingles.